Let's talk about the matters that gantry surface grinding machines need to pay attention to when working

Gantry surface grinding machine is composed of many components, the production process to make the grinding rod movement direction and the sand wheel shaft work direction consistent, so that it will be beneficial to work when the self-priming oil discharge quickly according to the radial clearance to produce oil wedges, which can improve the running characteristics, conducive to the production of no error.

Gantry surface grinding machine in the grinding process pay special attention to the following four points:

1. In the milling process, it is necessary to continuously tighten the front and rear rolling bearings (maintain a certain touch) to improve the milling efficiency and ensure the accuracy of the bearing;

2. Eliminate excess slurry at the top of rolling bearings anytime and anywhere to prevent flared period in front and rear rolling bearings;

3. When milling, try to avoid and moderately tighten the front and rear rolling bearings as much as possible to ensure the accuracy of the front and rear shafts;

4. After milling for a certain period of time, pull out the grinding rod, eliminate the grinding liquid in the grinding rod and the front and rear rolling bearings, check the grinding performance and the damage of the grinding rod, if the grinding rod is damaged, it needs to be repaired to ensure the consistency of the diameter of the front and rear rolling bearings.

There are problems that need attention in the production process of all machines and equipment, and the same is true for surface grinding machines. Only in the process of milling production with surface grinders, pay attention to the above four points, in order to make the surface grinding machine production level show, and then produce products that meet the requirements.

How to solve the vibration problem after the production of gantry surface grinding machine surface equipment

First, is the living environment of production and processing, high-precision gantry surface grinding machine around the same working environment is no way to place such as high-speed punches, CNC lathes and other CNC lathes with relatively large vibrations, it is easy to cause resonance, how to judge whether there is resonance? Stop the grinder, start the high-speed punch or CNC lathe, if the hand touches the grinder and there is vibration or numbness feels like it is affected. Therefore, it is necessary to separate the production hall.

Second, check the road surface, if the level of anchor bolts of the CNC lathe is not adjusted, it will cause the resonance of the CNC lathe. Since sometimes the surface flatness of the production and processing site is not too good, it is necessary to adjust the horizontal screw to make the CNC lathe reach a flat relative height. According to the twist of the anchor bolt, let each anchor bolt adhere to the site.

Third, if the vibration is not cleared after the above posture is done, it should be checked whether it is caused by the pavement wood floor is too bitter, if the pavement is a terrazzo floor or the paved floor block will be relatively firm, if it is a cement floor, the pavement will be weak and will cause resonance, how to deal with this situation? Can go to the plastic hardware store to buy a few pieces of gray-black rubber mat, thickness 6-10mm up and down, size 10 cm and floor cushion specifications slightly larger on it, loosen the anchor bolts, the rubber cushion under the horizontal cushion, can play a very large shock absorbing effect.

Fourth, if the vibration is not cleared, you can change a sand wheel to try, if the flange is not effective weight block calibration to install the weight block, then remove the weight block and install, really not work to change a new flange to try, the general problem can be solved.